Tree Watering Bag Installation Instructions
- Oct 11, 2018 -

Just wrap our tree watering bag around a tree, zip the two sides together, 

and fill it with water - that's it!

Step 1


Place back of bag against trunk, with zippers on the uphill side of tree.

Wrap both sides around trunk until zippers meet together:

Use one Bag setup for trees from 1 to 3 inches in trunk diameter (caliper).

Zip both sides of bag together from bottom to top.


Step 2

step_two_directions.gif

Lift up tag at top of bag to expose fill opening.

Insert water hose (up to 3 inch diameter), into fill opening, turn on 

water supply and begin filling.

Note: Fill bag only to approximately 1/4 capacity, then proceed to 

Step 3 below.


Step 3

step_three_directions.gif

Gently lift up on the two black straps at top of bag in order to fully 

expand bottom.

Note: Do not hang or suspend bag by black straps

If desired, add pre-mixed water soluble fertilizer and/or nutrients.


Step 4 

step_four_directions2.gif

Fill tree-watering bag with water to desired level and let drain.

Tree watering bag will be empty in approximately 5 to 9 hours.

        

Follow a fill schedule based on the size of your new  planting .

Once empty, remove bag from tree , move to another planting 

and re-fill, or store until needed again.